Erstellt am 16.05.2008 - 08:42

I have a small suggestion that would come in handy when using dithering function.

You can specify the dithering radius and the mount will dither around that point. And you can also specify the amount of seconds between each shot in the Camera menu to give the mount enough time to reach it's new location (a few pixels away). But sometimes for example 20 sec is just not enough and Guidemaster starts to capture while the mount is still on the move. Now...I could increase the time between each shot, but more time between shots equals less time for imaging.

How about another safety measure that will delay the camera to start the next shot unless the guidestar is within the guiding tolerance already specified under setup?

Erstellt am 18.05.2008 - 11:23

Thank you,
that's a good proposal, I'll try to implement this feature.

Bst regards,
Matthias